1 Scope
This part of ISO/IEC 9314 specifies the Physical Layer Protocol (PHY), the upper sublayer of the Physical Layer,
for Fibre Distributed Data Interface (FDDI).
FDDI provides a high-bandwidth (100 Mbit/s), general-purpose interconnection among
information processing systems, subsystems and peripheral equipment, using fibre optics or other transmission media. FDDI can be configured to support a sustained data transfer
rate of at least 80 Mbit/s (10 Mbyte/s). FDDI provides connectivity for many nodes distributed over distances of many kilometers in extent. Certain default parameter
values for FDDI (e.g. timer settings) are calculated on the basis of up to 1 000 transmission
links or up to 200 km total fibre-path length (typically corresponding to 500 nodes and 100 km of dual fibre cable, respectively); however, the FDDI protocols can support
much larger networks by increasing these parameter values.
As shown in figure 1, FDDI consists of
a) Physical Layer (PL), which is divided into two sublayers:
- A Physical Medium Dependent (PMD), which provides the digital baseband point-to-point
communication between nodes in the FDDI network. The PMD provides all services necessary to transport a suitably coded digital bit stream from no...
Открыть превью (PDF)Information processing systems. Fibre Distributed Data Interface (FDDI) - Physical layer protocol (PHY-2)
