Plastics piping systems for the supply of gaseous fuels. Polyethylene (PE) - Pipes
Открыть превью (PDF)Plastics piping systems for the supply of gaseous fuels. Polyethylene (PE) - PipesPlastics piping systems for the supply of gaseous fuels. Polyethylene (PE) - Pipes
Сайт использует cookie и счётчики посещений для работы и статистики. Политика конфиденциальности
1 Scope This part of ISO 4437 specifies the characteristics of pipes made from polyethylene (PE) for piping systems in the field of the supply of gaseous fuels. It also specifies the test parameters for the test methods referred to in this International Standard. In conjunction with part of ISO 4437-1, ISO 4437-3, ISO 4437-4, and ISO 4437-5, it is applicable to PE pipes, fittings and valves, their joints, and joints with components of PE and other materials intended to be used under the following conditions:
a) the maximum operating pressure (MOP) is based on the design stress determined from the compound minimum required strength (MRS) divided by the C factor, and taking into account rapid crack propagation (RCP) requirements;
b) a temperature of 20 °C as reference temperature for the design basis.
NOTE 1 For other operating temperatures, guidance is given in ISO 4437-5:2014.
For above ground application of pipes conforming to this International Standard, the pipes should be protected by a casing pipe, taking into account any relevant national regulations and installation practices or codes. This part of ISO 4437 covers three types of pipes:
— PE pipes (outside diameter d n ) including any i...
Стандарты, упомянутые в описании
