Vacuum technology. Standard methods for measuring vacuum-pump performance - General description
Открыть превью (PDF)Vacuum technology. Standard methods for measuring vacuum-pump performance - General descriptionVacuum technology. Standard methods for measuring vacuum-pump performance - General description
Сайт использует cookie и счётчики посещений для работы и статистики. Политика конфиденциальности
1 Scope This part of ISO 21360 specifies three methods for measuring the volume flow rate and one method each for measuring the base pressure , the compression ratio , and the critical backing pressure of a vacuum pump. The first method for measuring the volume flow rate (the throughput method) is the basic concept, in which a steady gas flow is injected into the pump while the inlet pressure is measured. In practice, the measurement of gas throughput may be complicated or inexact. For this reason, two other methods are specified which avoid the direct measurement of throughput . The second method for measuring the volume flow rate (the orifice method) is used when there is very small throughput at very small inlet pressures (under a high or ultra-high vacuum). It is based on measuring the ratio of pressures in a two-chamber test dome in which the two chambers are separated by a wall with a circular orifice. The third method for measuring the volume flow rate (the pump-down method) is well suited for automated measurement. It is based on the evacuation of a large vessel. The volume flow rate is calculated from two pressures, before and after a pumping interval, and from the volume of the test dome . Different effects, such as leak and desorption rates, gas cooling by nearly isentropic expansion during the pumping interval, and increasing flow res...
Упомянутые в описании и другие стандарты BS
